 |
||||||||||||||
|
||||||||||||||
|
 |
 |
 |
Walkthrough Page 3 |
|
|---|---|---|
|
||
|
Insert a pipe cleaner into the spindle hole as far as possible. Rotate the pipe cleaner inside the spindle several times being sure to make sideways contact with the inner surface of the spindle. Remove the pipe cleaner, clean away any debris, and repeat the process until the pipe cleaner comes out clean. Use Impact Air 45® autoclavable lubricant and a bristle brush to clean any fluid or residue from the chuck assembly. |
 |
|
||
|
Place the cleaned chuck assembly back into the spindle hole. Push the chuck in until it is fully inserted. |  |
|
||
|
Place the turbine - chuck side down - against a hard, flat surface. Insert a bur into the spindle as far as it will go. (approximately halfway). Grip the turbine, push down against the surface, and slide the bur in the rest of the way. |  |
|
||
|
Replace the O-rings (black O-ring at the chuck end of the turbine and the blue O-ring at the bur end of the turbine) and washers. |  |
|
||
|
|
|
Palisades Dental, LLC
111 Cedar Lane
Englewood, New Jersey 07631
1-800-664-8000 1-201-569-0050
Fax 1-201-569-0250
© 2009 Palisades Dental, LLC
Site design by Westchester Creative Group, Inc./Linear Design Group LLC